Go Handmade Safety Eyes Mix 12 pairs Black
Go Handmade Safety Eyes Mix 12 pairs Black - Black is backordered and will ship as soon as it is back in stock.
Couldn't load pickup availability
Shipping & Delivery
Shipping & Delivery
On the back of the safety eye, there is a plastic locking mechanism that ensures that the eye stays in place, and when fitted correctly, the eye will not fall off. The stem of the safety eye itself has some grooves, and no matter which groove you press the plastic part down over, the eye will stay firmly in place. The grooves are practical as the safety eyes can be attached to, for example, a sewn teddy bear made with a very thin piece of fabric, and the eye can also be attached to a teddy bear knitted with a very thick yarn.
Mounting:
1. It is important that the stopper is mounted close to the back of the eyelet - at the bottom of the stem.
2. Strengthen the stopper's hold on the eye/stem by melting the outer part of the stem.
3. Watch our video to see how to (easily) melt the end of the stem slightly and then press it wide.
4) This makes the end piece wider than the stopper hole, which greatly strengthens the installation.
5. Always remember to check that the eyelet and stopper are intact and that the fitting is firmly seated in the needlework.
The mix consists of a total of 12 pairs of eyelets:
- 8 mm: 2 pairs of eyes
- 10 mm: 4 pairs of eyes
- 12 mm: 4 pairs of eyes
- 14 mm: 2 pairs of eyes
NOTE: When making crafts and homemade items, especially for baby, it is important to be careful with the assembly. Especially careful with knots and loops. For safety: Always check carefully before use and discard if there are any signs of damage or wear.
As a guide, we also refer to the following:
- 'Eyes assembly' from GoHandmade (video)
- How to test that the safety eyes are mounted correctly